Epson7600/9600液晶屏報錯SERVICEREQ 00010000的解決方法
更新時間：2024/10/7 19:03:04,view:185epson打印機Epson7600/9600蘇州epson打印機售后服務(wù)中心客服熱線69616769，蘇州epson售后電話，epson售后網(wǎng)點， EPSON7600/9600液晶屏報錯SERVICEREQ00010005,維修視頻
00010000 走紙馬達(dá)讀取錯誤
1.連接PF 傳感器線有問題，或者是線插反了檢查下圖所示PF傳感器
2。馬達(dá)或傳感器的連接短路
3，光柵盤 污損 傳感器位置偏差 不讀碼盤
請參考下代碼解釋，實際情況實際對待
ErrorCode; 00010000 Description; PF Motor Encoder check error
Explanation During initial operation at power on or during PF Motor operation, there may be a case where the encoder pulse signal can not be recognized at specified intervals. In such a case, this message is displayed and the printer stops operating.
Cause of trouble Disconnected connector for the PF Encoder Sensor.
Disconnected connector for the PF Motor.
Broken wire for the PF Motor Encoder.
Inverted wiring for A and B pulses.
Inverted wiring for the PF Motor.
PF Motor short
PF Motor continuous excitation (voltage applied continuously, motor revolutions unusual)
Broken power supply fuse for the PF motor driver (on the Main Board )
Points to be checked 1. The PF Encoder Sensor and the PF Loop Scale must be free from dust and dirt or any other foreign matters.
2. Execute encoder checking by the Service Manual "1.4.6.1 Self Testing Menu (SELF TESTING)" (p.91) in "Maintenance Mode 2".
3. The PF Timing Belt must be free from any defects and the belt must be in proper tension.
4. The PF Roller must rotate smoothly, free from undue load.
5. Measure the resistance value of the PF Motor (17.9 ± 15% [Ω]). If the PF Motor is found in short mode, replace the BOARD ASSY.,MAIN at the same time.
6. All the harness must be connected properly and free from short circuit or broken wire.
Remedy 1. Check for dirt, paper dust or damage to the Loop Scale
2. Connect the PF Encoder Sensor connector or PF Motor connector.
3. PF Timing Belt Tension Adjustment (Service Manual p.378)
4. Replace the PF Encoder Sensor (p.357)
5. Replace the Motor Assy., PF (p.349)
6. Replace the C593 MAIN Board (p.226)
熱門圖文