佳能C5051出現E000075-0103
更新時間：2024/9/15 19:08:07,view:679佳能打印機C5051蘇州佳能打印機售后服務中心客服熱線69616769，蘇州佳能售后電話，佳能售后網點， 佳能c5051出e000076, 佳能c5051復印機復印時紙張下部顏色偏淡怎么解決, 佳能c5051e000001-0001, 佳能c5051e0000750003, 佳能c5051怎么進入維修模式,維修視頻
佳能C5051出現E000075-0103
佳能c5051蘇州維修服務電話696l6769 曹汔菠 2018/9/2 15:23:48 The E000075 error code refers to the ITB belt shifting front to rear of the machine and can not compensate. There are two causes that will make this happen.
a) The machine that is not level
b) Uneven thickness of the ITB belt from front to rear.
To resolve this issue, first observe the ITB Position value of displacement in service mode under Copier > Display > Misc > ITB-POS. The range is between -300 to 450. If the value is very close to the high end or low end, perform the following:
a) Check to make sure that the machine is level.
b) After leveling the machine, run Copier > Function > MISC-P > ITB-INT in service mode
c) Check Copier > Display > MISC > ITB-POS again to make sure the value is approximately within the mid range
d) If the value in step c is not within mid range, remove the ITB belt and reverse it from front to rear and repeat the prior steps again.
用戶 2019-10-14 佳能e000075-0103
佳能c5051蘇州維修服務電話696l6769 曹汔菠 2018/9/2 15:23:48 The E000075 error code refers to the ITB belt shifting front to rear of the machine and can not compensate. There are two causes that will make this happen.a) The machine that is not level
b) Uneven thickness of the ITB belt from front to rear.
To resolve this issue, first observe the ITB Position value of displacement in service mode under Copier > Display > Misc > ITB-POS. The range is between -300 to 450. If the value is very close to the high end or low end, perform the following:
a) Check to make sure that the machine is level.
b) After leveling the machine, run Copier > Function > MISC-P > ITB-INT in service mode
c) Check Copier > Display > MISC > ITB-POS again to make sure the value is approximately within the mid range
d) If the value in step c is not within mid range, remove the ITB belt and reverse it from front to rear and repeat the prior steps again.
用戶 2019-10-14 佳能e000075-0103
熱門圖文